Memorex LOCK - VERSION 2-24 Especificações descarregar pdf (Página 142)

Autoattach Installation for VM/ESA Version 2 Release 2 Using VMSES/E

3-18 BIM-EPIC Installation and System Guide

Place the following next to this entry

COPY / = = E

and press ENTER

Move the TXTLEPIC module to the

LOCALMOD disk. If the LOCALMOD

entry noted in Step 2, above is not E then

use the file mode from Step 2.

Place the following next to this entry

ERASE

and press ENTER

Remove the TXTLEPIC module from the

“A” disk.

Build a new CP nucleus. If prior steps did not complete properly, errors can be produced by

VMFBUILD. Correct any errors before going on to the next step.

VMFSIM LOGMOD 2VMVMB20 VVTLCL E

TDATA :PART CPLOAD EXC :MOD

LCLEPIC

Add a CPLOAD entry to the Version

Vector Table The command is typed on a

single line. If the LOCALMOD entry

noted in Step 2, above is not E then use

the file mode from Step 2

VMFBLD PPF ESA CP CPLOAD ( ALL

Build the CP Nucleus. Make sure the

following message has a 0 return code:

VMFBLD1851I (1 of 1) VMFBDNUC

completed with return code 0

XEDIT CPLOAD MAP

To check for unresolved/undefined

SET CASE MIXED IGNORE

Ignore case when searching

ALL /UNRESOLV/

ALL /UNDEFINE/

If any unresolved or undefined items are

found, do not continue until they are

corrected.

QUIT

End the XEDIT

Move the new nucleus into production by copying the CPLOAD MODULE to the CP PARM

disk.

Q CPDISK

Display the CP PARM disks. You will see a

display similar to the following:

PARM1 MAINT 0CF1 A R/O

PARM2 MAINT 0CF2 B R/O

CPREL A

Release the PARM1 disk.

LINK MAINT CF1 CF1 MR

Link to the PARM1 disk. If PARM1 was not

CF1, then use the cuu from the Q CPDISK

display.

STEP 10

STEP 11

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 358 359

Comentários a estes Manuais

Sem comentários

Memorex LOCK - VERSION 2-24 Especificações Página 142

Comentários a estes Manuais

Manuais e produtos relacionados com Software Memorex LOCK - VERSION 2-24