Memorex LOCK - VERSION 2-24 Informações Técnicas descarregar pdf (Página 324)

100

101

Identifying VSE/ICCF and Interactive Partition GETVIS Requirements

7-56 User Reference

Use Pursuant to Company Instructions

Identifying VSE/ICCF and Interactive Partition

GETVIS Requirements

Description The following GETVIS discussion applies to ICCF pseudo partitions and

not to the ICCF partition.

An ICCF pseudo partition has 48K of GETVIS. This allocation cannot be

changed. If BIM-EPIC is active in the pseudo-partition, more than 48K of

GETVIS will often be required to initiate many programs, for example,

DTSUTIL. If sufficient GETVIS is not available, abnormal termination

may result or BIM-EPIC messages EP042 and EP042A, (referring to an

insufficient GETVIS condition) may display. If DTSUTIL is invoked

from the command line with one of these commands, the following

insufficient GETVIS condition may occur:

$DTSUTIL

/RUN DTSUTIL

If you invoke DTSUTIL from the VSE Interactive Interface, a CDLOAD

failure has been allocated to the ICCF/CICS partition itself.

Circumvention When using DTSUTIL, you can work around the GETVIS space

limitation by storing a member named DTSUTIL in a VSE/ICCF library,

preferably the common library. This member will contain the following:

/LOAD DTSUTIL

/OPTION GETVIS=256K

This same technique can be used for any program which ICCF runs in a

pseudo-partition.

When the library file has been stored, you can run the program with the

ICCF /EXEC command. Using DTSUTIL as an example, enter the

following ICCF command:

/EXEC DTSUTIL

ICCF searches for the first DTSUTIL member in an ICCF library and

executes the ICCF job control found in that member. If adequate GETVIS

storage is requested, the program will successfully execute.

1 2 ... 319 320 321 322 323 324 325 326 327 328 329 ... 567 568

Comentários a estes Manuais

Sem comentários

Memorex LOCK - VERSION 2-24 Informações Técnicas Página 324

Comentários a estes Manuais