Memorex RX 1 Smart Manual de Instalação descarregar pdf (Página 28)

Simrad MX500 | 27

mation in these other screens relate to the MOB position,

not the next waypoint in the active route, until MOB is

canceled.

To cancel a MOB condition, make sure you are in the MOB

Plot screen. Press the EDIT function key, then select the

Cancel MOB softkey.

The MX500 is also capable of performing the MOB func-

tion from a remote contact closure. If the contact closure

is made for 1 second, the input is registered as a Mark

Position. If the contact closure is made for 3 seconds,

the input is registered as a MOB Position. Refer to the

Installation Section of this manual for interface instruc-

tions.

GOTO

This function key allows you to quickly create a route

from your present position to waypoint or a route. This

single waypoint route can use an existing waypoint from

the Waypoint Bank, or you can quickly create one by

either defining the appropriate coordinates or specifying

a range and bearing.

Be careful when you use this selection, as it will erase

your current active route when it creates the new one.

Read through the ROUTE and PLOT sections of this

manual to find other ways to use this key within an active

route.

POWER ON/OFF & LIGHT

This triple function key turns the unit on and off. When

depressed while the unit is on, you will be prompted to

select a YES or NO softkey to confirm your action. This is

known as a software power off.

If the operating program should hang up for any reason,

you can also perform a hardware power off by continuing

to depress the power on/off function key for about 5 sec-

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 261 262

Sem comentários

Memorex RX 1 Smart Manual de Instalação Página 28