Memorex RX 1 Smart Manual de Instalação descarregar pdf (Página 166)

164 | Appendix E - AIS connection for MX512 only

Note: A total of 35 lines are available under the AIS Static menu. If only 10 lines

are available when you scroll down, the MX512 may not be communicating with the

transponder. Verify that the “AIS Connected” value is set to YES and the correct

transponder type is selected.

Display Field Descriptions:

AIS, ECDIS, PILOT, Long Range, Ext. GPS Connected:

Highlight the

softkey then press the ENT key to select Yes or No. Yes means that

the selected unit is connected to the MX512.

ECDIS, PILOT, Long Range, Ext. GPS Port:

Use the

softkey to select the serial port number to which the device is connected.

“AIS Port” is pre-selected to NMEA5, Long-Range Communication port is NMEA 9, ECDIS

is on NMEA 10 and the Pilot port is on NMEA 7.

ECDIS and PILOT Msg Config:

Use the

softkey to select between IEC or PAIS protocol for the communication

standard used with the associated device. IEC protocol is preferred for most AIS

interface.

Long Range Reply:

Use the

softkey to select between AUTO, Manual or Off. In Manual mode, the

user is prompted to reply to the Long-Range system when interrogated. In Auto mode,

the MX512/AIS automatically sends a reply when interrogated. In Ext. Appl (External

Application) mode, the MX512/AIS passes the request onto the high-speed ports (ECDIS

& Pilot), and waits for their response to prepare answer back to long range system.

MMSI:

A unique 9-digit Maritime Mobile Service Identity number used for identification of ship

and message (administrator password required).

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 199 200

Sem comentários

Memorex RX 1 Smart Manual de Instalação Página 166