Memorex RX 1 Smart Manual de Instalação descarregar pdf (Página 36)

34 | Keypad & Display Description

You can then choose to select another waypoint using the same method, select 8

Escape to go back one level and use another method to enter waypoints, or select

Done to go back to the main menu.

Don’t forget to press the

9 EDIT key to end your editing.

Insert New Waypoint

The following example assumes RTE1 is empty. Follow the directions in the Erasing an

Existing Route section to start with an empty route if you have waypoints in the RTE1

screen.

Select the

1 RTE key until the RTE1 screen is displayed.

Press the

2 EDIT key to enter the edit mode.

Highlight

3 Insert new Waypoint softkey from the display and press ENT.

Choose either 4 Bearing, Distance or Lat/Lon (Grid Point, or TD if you are using other

coordinate systems). Use the EDIT keypad to type in the range and bearing from

the previous waypoint (or present position in the case of the rst waypoint) or the

coordinates you want and their appropriate description.

When the information is correct, highlight the

5 Done softkey and press ENT.

You can then choose to enter another waypoint using the same method, select

Escape to go back one level and use another method to enter waypoints, or select

Done to go back to the main menu.

Don’t forget to press the

7 EDIT key to end your editing.

Insert Route

The following example assumes RTE1 is empty. Follow the directions in the Erasing an

Existing Route section to start with an empty route if you have waypoints in the RTE1

screen.

To perform this function, you must also have defined a route in the RTE2 screen. The

RTE2 description follows later in the Route section.

Select the

1 RTE key until the RTE1 screen is displayed.

Press the

2 EDIT key to enter the edit mode.

Highlight

3 Insert Route softkey from the display and press ENT.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 199 200

Sem comentários

Memorex RX 1 Smart Manual de Instalação Página 36