Memorex RX 1 Smart Manual de Instalação descarregar pdf (Página 26)

24 | Keypad & Display Description

Waypoint Bank (WPT1) where a symbol is used as the first character of the waypoint

description. The Panorama and Plot screens will automatically place these navigation

markers on the screen as you approach them.

The degree values that you see are your Course Over Ground (COG), as calculated by the

GPS receiver’s position fix to position fix, and Bearing (BRG) from your present position

to the waypoint. The speed value is your Speed Over Ground (SOG) as calculated by the

GPS. The distance value displayed as the Range (RNG) is calculated from your present

position to the waypoint. The Time-To-Go (TTG) is the calculated time it will take you to

reach the waypoint, based on your Waypoint Closure Velocity (see NAV4 description).

To keep the screen from jumping around when you are stopped, the screen freezes the

graphic representation when your speed is under 0.5 Kn in DGPS mode or 2.0 Kn in GPS

mode. Once you get underway, your course details will update appropriately.

You will see a RL or GC symbol in the upper right corner of the display indicating whether

you are navigating under Rhumb Line or Great Circle. This is set in the CFG Navigate

menu.

If you press the EDIT key, the Panorama Display Option screen will allow you to customize

the information presented.

View

• - allows you to adjust the display for a Close (zoomed-in) or a Far (zoomed-out)

representation of your route.

Show Waypoints

• - allows you to turn waypoints which are not part of the active route

on and off.

Show Active Route

• - allows you to turn the course line on or off on the display

(assuming a symbol is entered for the first character of the waypoint name).

Show Off Track Limit

• - allows you to turn the cross-track error limit lines on or off on

the display.

Show Data Window

• - allows you to select between the two NAV 1 display types

depicted at the beginning of this section, one in which the data is displayed in various

parts of the graphic screen, the other in which the data is displayed in a separate

window to the left of the graphic screen.

If you drift outside of your cross-track error limit and you decide not to return to your

original course line, you can reset your course line from your present position to the

waypoint by highlighting the Reset XTE softkey from the display, and pressing the ENT

key.

The Skip Waypoint softkey allows you to skip the waypoint you are presently going to, and

advance to the next waypoint. For example, if you were under way and nearing waypoint

5 and you decide you want to go on to waypoint 6 now, press the EDIT key, highlight the

Skip Waypoint softkey, and press the ENT key. If you make a mistake and you want to go

back (unskip) to waypoint 5, you can do this by the following:

Go into the

1 RTE1 screen.

Press

2 EDIT in the RTE1 screen.

Highlight the

3 Route Control softkey and press ENT.

Highlight the up arrow softkey (fourth from the left) and press

4 ENT once.

Press the

5 EDIT key again.

Refer to the Route section of this manual for more details about skipping and unskipping

waypoints.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 199 200

Comentários a estes Manuais

Sem comentários

Memorex RX 1 Smart Manual de Instalação Página 26

Comentários a estes Manuais