Memorex RX 1 Smart Manual de Instalação descarregar pdf (Página 79)

Keypad & Display Description | 77

Initial Pos - Initial Position Entry

This screen is provided to help the GPS receiver in the smart antenna to get a faster

first position fix. While the smart antenna is capable of computing its position without

any user input, this feature can cause a position fix to occur several minutes earlier.

Another time this feature is useful is when the MX51x has been moved over 300 miles

from the last location it was used while in the off condition. Again, the MX51x will

calculate a position fix without any user input in this circumstance. However, moving the

MX51x to a new location and not inputting a new initial position will cause the receiver

to select a satellite constellation consistent with the last known receiver coordinates.

In this event the MX51x may “get lucky” and find common satellites between the old

position and the new location, or it may take up to 20 minutes to go through all of the

constellation possibilities. Note that the MX51x will stay on the original constellation for

15 minutes before attempting other constellation possibilities. We assume the MX51x will

be turned on and off in the same general area each time, and we provide the unit every

opportunity to try and track satellites at the last known coordinates.

LAN - Local Area Network

This feature allows the MX51x to communicate with another MX51x via LAN interface

(RJ45). This data link is used by the MX51x for dual control, integrity monitoring, and

multiple control applications. Below are IP addresses used by the Host and Client units

within its local network.

Type IP Address

Host 192.168.100.250

Clients (See below)

Number 1 192.168.100.251

Number 2 192.168.100.252

Number 3 192.168.100.253

Number 4 192.168.100.254

MX 510 IP Address Table

To activate LAN, press the EDIT key and press the ENT key to activate the Change

softkey to change LAN Enabled to Yes. Use the Change softkey to modify the options

described below:

Type - select between Host or Client. In a dual or multiple unit control system, the

Master will be the Host and the Slave(s) will be the Client(s).

Number - this option is only available when Type is Client. The available values are 1,

2, 3, or 4 (which determines the IP address of the CDU). Each Client has to be

assigned with a unique number (1, 2, 3, or 4). Any two or more Clients with the

same number will create an IP address conflict, and therefore, will activate an IP

Conflict Alarm. Please refer to the previous IP address table for the designated IP

numbers.

When the connection is successful, the Status will display ESTABLISHED.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 199 200

Sem comentários

Memorex RX 1 Smart Manual de Instalação Página 79