Memorex RX 1 Smart Manual de Instalação descarregar pdf (Página 49)

Keypad & Display Description | 47

The 5 Change softkey is highlighted at this point, press ENT key.

Wait for the MX51x to recognize the USB device before proceeding.

Highlight “Data type”7 then press ENT to change to either Waypoints, Route, Plot,

Cong or All. Using “All” will restore everything.

Highlight

8 Restore softkey then press ENT.

It will pop-out a dialog window asking if this is what you want to do. Answer YES 9

(0r NO) by pressing the ENT key (or scroll to NO if you are not sure and press the

ENT key).

Depending on the amount of data, it may take 5 to 10 seconds or longer to

complete this action. The display will advise you when it is done restoring.

Before removing the USB, set the USB connected to NO. This is important to 11

prevent causing damage to the USB device or to the data in it.

Downloading Waypoints & Routes to Other Devices

The MX51x can download all stored waypoints, routes and configuration settings to other

NMEA 0183 compatible devices which accept the WPL, RTE, and Rnn data sentences.

These sentences are controlled in the CFG1 screen NMEA Out (1 or 2) for the identifier

given below.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 199 200

Sem comentários

Memorex RX 1 Smart Manual de Instalação Página 49